FEED TIME PROGRAMMING:
First feed time.
1) Hold down the #1 & #2 PB at the actual
time of day the first feeding is to occur.
2) Hold
both PBs down until the LED blinks twice and stays on.
3) Release
both PBs. The LED remains on.
4) Depress and
hold the #2 PB. The LED blinks twice and turns off.
5)
Release the #2 PB. The LED turns back on.
If no additional times are programmed the LED will turn off in
30 seconds.
Additional feed times Must be programmed
prior to the LED turning off.
6) To program the
2nd feed time momentarily depress the #1 PB one time for each hour,
beyond the first feed time.
That is: The first feeding is at 7 AM and the second feeding is to be at 9 AM, momentarily depress the #1 PB two times.
7) At the desired feeding time depress the
#2 PB until the LED blinks twice
and turns off. Release the PB, note the LED turns back on.
This will store the second feeding time.
8) To program
the 3rd feed time momentarily depress the #1 PB one time for each
hour beyond the last set feed time.
That is: The next feeding is to be at 6 PM, depress the #1 PB 9 times.
9) At the desired feeding time depress the #2 PB
until the LED blinks twice and turns off. Release the PB,
the LED remains off.
10) The LED will automatically turn
off after the 3rd setting. If less than 3 feed times are programmed
the LED will turn off after 30 seconds.
12) Note:
All feed times must occur within a maximum of 11 hours after the
initial feed time.
ONE FEEDING PER DAY:
1) To set the unit to feed only one time per
day simply complete steps
1,
2, 3, 4 & 5 in “FEED TIME PROGRAMMING above.
2) Following
step 5, allow LED to time out and turn off (approximately 30 seconds).
TWO-TIME-A-DAY TIMER: (Default self-programming)
1) To activate the timer’s self-programming
function hold down the #1 &
#2
PB at the actual time of day you desire the first feeding to occur.
2)
Hold the PBs down until the LED blinks twice and stays
on.
3) Release the #1 & #2 PB. The
LED will turn off in 30 seconds.
4) After the LED
turns off, momentarily depress the #2 PB. LED turns back
on for 2 seconds and then turns off.
At this time the timer will feed at the set time and 9 hours later. The motor will run at high speed for 6 seconds.
BACK UP OF FIRST FEED TIME:
Back up of the first feed time allows the timer to be set without physically being at the timer, at the desired feed time.
Example: You arrive at the timer location at 11:00 AM and desire to set the first feed time at 7:00 AM, a time difference of four hours earlier.
1) To set the first feed time of the day hold
down the #1 & #2 PB at the time of day you arrive at the feed
location.
2) Hold the PBs down until the LED blinks
twice and stays on.
3) Release the #1 &
#2 PB. The LED remains on.
4) Prior to the
LED turning off, momentarily depress the #1 PB the number of hours
it is desired that the timer be backed up.
Note: The timer may be backed-up from 1 to 23 hours.
5) When the selected hours have been backed-up depress
the #2 PB until the LED blinks twice and turns off. When released
the LED turns back on.
6) You may now program
an additional 1 to 9 feeding times, if desired.
