PROGRAMMING FOR LITLE-BEE   Back      

LITTLE-BEE TIMER PROGRAMMING:

The LITTLE-BEE "Walk Away" Timer is designed to provide the user with the easiest to use digital timer available. Therefore, there is no programming required.

Simply install the 4 D-Cell batteries, set the initial feed time, and "Walk Away". The microprocessor will take over and cause the timer to feed at the initial feed time and 9 hours later for six seconds.

When the batteries are installed/replaced, the initial feed time must be reset. See "Setting of First Feed Time".

SETTING OF FIRST FEED TIME:

Hold SET push button down until LED light comes on (SET push button is located on the pc board).
Release SET push button - LED turns off within 30 seconds.

BACK UP OF FIRST FEED TIME:

Back up of the First Feed Time allows the timer to be set without physically being at the timer, at the desired feed time.
Example: You arrive at the timer location at 11:00 AM and desire to set the first feed time at 7:00 AM, a time difference of four hours earlier.
To back up the first feed time, depress the SET push button until LED light comes on. Release SET push button. Momentarily depress SET push button for each hour of back up. LED turns off when push button is depressed. NOTE: Back up must be accomplished within 30 seconds.

MOTOR TEST:

Momentarily press TEST push button on outside of case. Motor will run following a 10 second delay.