PUSH BUTTON SWITCH LOCATIONS:
The pushbutton in the lower left hand corner of the PCB is the "TEST" button.
The pushbutton to the immediate right of the "TEST" button is the "SET" button.

FEEDING:
The initial feed time is the first time during the day that the timer will feed. This time is usually in the early morning, ie.6:00 AM, 6:15 AM, 7:40 AM, etc. To set the initial feed time simply hold the SET button down at the desired time of day for the first feeding. The button must be held down for ten seconds. Release the button and note that the motor will run following an 10 second delay.

If the motor does not run, it is an indication that the initial feed time failed to set. Try setting it again.

ADDITIONAL DAILY FEED TIME:
The 2nd feeding will automatically occur 9 hours following the initial feed time.

DURATION OF FEED TIME:
The feeding duration is automatically set for 6 seconds, it is not adjustable.

FEEDER SELF-TEST:
A delay Test button is provided to allow the timer motor to activate a timed feed. Simply press and release the TEST button. Upon release of the TEST button, a delay of 10 seconds is provided before motor activation. This delay provides the user time to move from the feeder before feed is dispensed.